![]() We are at this point only able to connect to the file shares already setup on the NAS. The reason for these error messages is that the software for these servers are requiring something called TLS 1.0, and that browsers have dropped support for these TLS versions.Īs Netgear no longer is releasing firmware upgrades to enable support for TLS 1.2 means that we are not able to login to the admin interface for our Netgear ReadyNAS servers to perform any further configuration or maintenance, etc. You therefore now simply get errormessages and cannot access the admin interface. The admin interface of the server should open up in your browser, and this is where the problem start as the sw on these NAS servers are no longer supported by most browsers. Next, you would click to access the admin interface of the desired NAS server. You would normally launch the RAIDar software, and this will scan your network for available ReadyNAS servers. To access the backend admin interface for these servers you would normally use a SW called RAIDar which can be found on: On the specifications side there are a good few differences between these, but I am not going into those differences here as that is not relevant to this article. In the picture you can see the V1 versions at the bottom in light grey color, while the V2 versions is on top in the darker grey color. Typically the first one (NV+) is the one using the SPARC processor, and the second one (NV+ V2) is the one using the ARM processor. Without going too much into the nitty gritty part of these servers I would personally categorise my ReadyNAS servers as follows: Up until recently Netgear has been providing regular upgrades, but many of these NAS servers have now entered EOL - End Of Life, and Netgear hence does not provide the updates required so that these can be used into the future. The technology has hence been around for quite a while, and as these become older there is also popping up a few hurdles as the technology they depend on is becoming obsolete. To answer the thread title: what you did do wrong is to purchase and install Lion.As I mentioned in my previous post about the Netgear ReadyNAS servers, I have been using and recommending these servers since 2008. I skipped Vista, I'll skip Lion, the mouse that roared. With that experience and other niggles, poor performance and battery life, I am back to Snow Leopard, 20 quid poorer and richer for an experience. Very Apple, let hundreds of 3rd party manufacturers address your lack of backwards compatibility for you, who cares what users need, the caravan will move on. SMB however is still giving problems and Time Machine has been hardwired to the new auth scheme, so no cure for that.Īpple: listen up and learn from Microsoft - when they switched to NTLMv2 for the very same reasons as you, they allowed for backwards compatibility, via UI, documented. This will cause the AFP Client to create the full preferences fileĬode: sudo defaults write /Library/Preferences/ afp_disabled_uams -array "Cleartxt Passwrd" "MS2.0" "2-Way Randnum exchange" sudo chmod o-w /Library/Preferences ![]() To turn on "DHCAST128" support please do the following:ġ) Launch /Applications/Utilities/Terminal and do:Ĭode: sudo chmod o+w /Library/Preferences defaults write /Library/Preferences/ afp_host_prefs_version -int 1Ģ) From Finder, select an AFP server, or use "Connect To.". ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |